Rough Cut Mower AcrEase Model MR44B

44″ rough cut model with a non-commercial grade single cylinder electric start engine and manual clutch blade engagement. Works great behind an ATV for smaller acreage jobs or tight clearance conditions.

Features

44″ Cutting Width
19 HP Briggs & Stratton Engine
Commercial Grade Deck Assembly
4 Tire Design
Quick Single Crank Height Adjust System
Height Adjustment Range From 2″ to 8″
Manual Clutch Blade Engagement
Conservative 2″ Diameter Sapling Rating
Pull Directly Behind or Fully Offset to the Side of the Tow Vehicle.

19HP Briggs & Stratton Professional non-commercial grade single cylinder engine

RC roughcut spindle 2016
The blade spindles used on the AcrEase mowers are built out of heavy duty welded steel hubs, 30mm (1-3/16″) steel shafts, machined steel blade holders and large sealed ball bearings.

RC 44RC Height Adjust
The cutting height can quickly and easily be adjusted from 2″-8″ with the single crank height adjustment system.
RC Roughcut Deck
The main deck is built out of 10 GA (.135″) thick steel with a 3/16″ thick steel top plate for reinforcement. An additional 1/4″ thick steel plate is welded in the blade spindle mounting location. The three layers of steel in the blade spindle mounting area add up to just under 5/8″ thick.
RC roughcut underside
Unique twin blade design provides more of a mulch action that reduces the size of the clippings and reduces bunching.
RC Manual Clutch Models
The blades are easily engaged by simply shifting a manual clutch lever.
RC ATV Tongue Clevis
The tow bar features a farm clevis type connection. This system provides more degrees of motion than most types of hitching systems. This is necessary to prevent binding in rough uneven terrain.
RC Fuel Tank 3.25 Gallon
Large 3-1/4 gallon fuel tank that provides 3 to 3-1/2 hours of run time

Floatation Kit
An extra front and back tire can be added to the center section of the mower deck.

– Great for mowing around ponds and on rough uneven ground where scalping would normally occur

– Clamping style receiver allows for adjustments from side to side with both the front and rear tires

– Pinned receivers make for quick kit removal when not needed

– Works on all existing and new rough cut mowers

Wetlands Kit
The Wetlands Kit consists of an extra set of tires and mounting brackets.

– Great for wetlands or marshy areas that stay wet all year around

– Works well in combination with small personal amphibious vehicles and ATVs/UTVs with tracks

– Kit more than doubles the tire surface area in contact with the ground

– Easy to install. Works on all existing and new rough cut mowers.

– The rough cut mower will not float with the wetlands kit installed. Water greater than 2-3″ in depth should be avoided.

– With the Wetlands Kit installed the minimum cutting height is 3.5″-4″.

– Works on all existing and new rough cut mowers

Electric Lift Kit
The Electric Lift Kit consists of all of the mounting hardware, brackets, electric actuator and wiring with remote control panel.

– Great for constantly changing terrain and grass/brush heights

– Allows for quick cutting height changes on the go from the seat of the tow vehicle

– Raise up and over rocks and logs with ease

– Heavy duty 1500 lb linear screw actuator made by Linak

– Works on all existing and new rough cut mowers